Groundwork Chico ConcreteGroundwork Chico Concrete

Garage floor concrete in Chico CA - a slab built for how you'll use the space

Garage floor cracked, dusty or sinking? We pack a solid base and pour a new slab, finished on schedule so the surface wears well.

Covered brick patio with a concrete floor, stone outdoor kitchen counter, and cushioned seating beneath a wood ceiling.

I measure and price every job

I come out myself to look at your garage, measure it and write the estimate, and our crew of finishers and laborers does the work. What we write down is what we build, so you know on pour day what you're getting.

Pouring concrete since 2013

We've been in business since 2013, based in Chico and working across the cities around it, including Durham, Oroville and Paradise. Most of our calls come from homeowners and property owners nearby. If your city isn't on our list, call and ask.

Licensed and fully insured on your job

To get your garage floor measured and priced, call (530) 399-1528 or fill out our estimate request form. It helps to know how you'll use the garage and what's wrong with the old floor before I come out.

Garage floor concrete in Chico

Garage floor concrete in Chico is the work of tearing out a worn floor or starting fresh, then forming, pouring and finishing a new slab inside your garage. Groundwork Chico Concrete does it for homeowners whose floor is cracked, dusty, sinking or holding water by the door.

Most calls start with something you can see, like a crack that keeps opening, gritty dust that comes up every time you sweep, or a low spot where water sits after you pull in wet. Under that, the cause is usually a base that settled because it was raked flat instead of dug out and packed, or a top that was finished too late. Replacing the floor means fixing what's underneath, not just the surface.

The price moves with the size of the floor, how much old concrete comes out, how much base work the ground needs and what goes under the slab. The schedule mostly turns on the pour date and the weather, and your written estimate lists each step so you know what you're paying for. California's license board describes concrete contractor work as forming, pouring, placing and finishing flat concrete, and that's the work our crew does on a garage floor.

Garage floor concrete, from the ground up

What goes under your slab

Before I write anything, I ask whether you'll coat the floor, heat or cool the garage, or join it to the house, because that decides what goes under the slab, and it can't be added once the concrete's down. A floor that just parks a car needs less underneath than one that'll become a workshop or a room. If you'd like more than a plain gray surface on top, we can talk through decorative concrete at the same visit, so the finish and the layers below get planned together.

Base first, finish second

The part you won't see keeps the floor flat. We dig out to the subgrade, the soil the slab rests on, and pack the base firm rather than raking fill level, because a raked base settles with the dirt. Where a lot sits on Chico series soil, the ground is very deep and well drained, but lots vary, so I check yours. The base is hidden on day one, so it's often the first budget cut, and it's the last one I'd make. If a slope crowds the garage, a concrete retaining wall may belong in the plan.

Finishing and joints on schedule

On pour day we keep the finishing and joint cutting on schedule, because timing shows in the surface, and a top worked too late or in midday heat ends up weak and dusty. Control joints are shallow cuts that give the slab a planned place to crack, in a straight line instead of wandering across the floor, so we lay them out before the pour. We also slope the floor toward the door so water runs out, not toward the house. The work is backed by our satisfaction guarantee.

Get a written estimate for your garage floor

We reply within one business day to set a time for me to come out, measure your garage and talk through how you'll use it. The estimate is free, done on site and comes with no obligation.

(530) 399-1528

How a garage floor job goes

  1. Measure, photos and questions

    After you call, I come out, measure the garage, take photos and ask how you'll use the concrete. Show me the cracks, low spots or dusty patches on the old floor, since they usually point to what went wrong underneath.

  2. Written estimate and permit check

    We send a written estimate that lists each step. If a permit is part of the job, we find out which city or county office handles your address and work through the application and inspections with you before we set a date.

  3. Pour, finish and walk-through

    Our crew does the prep, forming, pour and finish, then the slab cures, the wait that lets it harden before you put it to use. I go over the work with you against the estimate before we call it done.

Garage floor questions from Chico homeowners

When is the best time to pour a garage floor in Chico?

The best day is one when finishing, joint cutting and curing can happen on time, because poor timing can lead to cracks, dusting, uneven spots and poor drainage. Hot-weather trouble can show up any time of year but usually comes in summer, and wind makes heat and dry air worse. On a summer pour, ask us how we'd handle wind.

Do I need vapor control under my garage slab?

You may, if the garage will be heated or cooled, coated, or connected to living space, because garage slab guidance says it may be important then. If you'll coat the floor later, the same guidance says to check its moisture and surface first, since a young floor can look dry and still keep a coating from bonding.

Who issues building permits in Chico and Butte County?

In Chico, the City of Chico Building Division issues building permits and inspects properties, and its permit page asks for a city business license number and a California contractor's license number. The Butte County Building Division handles permitting, plan review and inspection, so the office you deal with depends on your address.

How much can a contractor ask for up front in California?

In California, a contractor can ask for no more than $1,000 down on a home improvement job, and less on smaller jobs, because the state contractor board caps the down payment at a share of the contract price when that's lower. Every other payment has to be listed in the contract and match work already done or materials delivered.